Flatsawn Lumber Is Not So Flat: How To Fix Cupped Wood, Pt. 2
Flatsawn Lumber Is Not So Flat: How To Fix Cupped Wood, Pt. 1

Flatsawn Lumber Is Not So Flat: How To Fix Cupped Wood, Pt. 2Now, let’s say you didn’t follow this advice and your panels developed a cup in them. They were planed and sanded flat and ready to be put into the door frame before you left the shop, but when you returned the next morning they had a noticeable rock. Since everything was already to final thickness, what options do you have? There is no meat left to machine flat and the wood can’t really be bent back into shape… or can it?

No, it can’t really be bent back, but it can be coerced back by doing the reverse of what caused the cup in the first place. The key is understanding the cause of the problem.

First, you need to identify the wet side and the dry side. If you are looking at a cupped panel from the end and it is shaped like a rainbow with the legs down, then the bottom side is the drier side. It is drier, tighter and smaller, and the outside edges are pulling together. The top side is wetter, looser and bigger, and its outside edges are pushing apart. These two forces, one pushing and one pulling, are working together to make a cupped panel.

After you have identified the problem, the solution is to treat the panel to the opposite conditions. This can be done by drying the wet side or wetting the dry side, but since almost all problems in woodworking are from wood that is too wet (at least around here), you should choose to dry the wet side.

I recommend to use a hairdryer for convenience, but on nice sunny days you can put the sun to work for you too. Both work fine, but the sun can fix a lot of panels at a time, quickly and quietly. The sun works great because it focuses all of the drying energy on just one side, and it focuses it on the entire side, not on just one spot like a hairdryer. (Be aware that some woods, like cherry, change color quickly in the sun and may be a better choice for inside drying).

The process is simple. Put the dry side down on a flat surface, one that restricts air movement across the bottom of the wood. The wide board or panel will be sitting like a rainbow, with the two legs down and the center up. Then just proceed to dry the top side, either with the sun or a hair dryer. If you are not in a hurry, you can simply move the wood to a drier environment, like the inside of your house on a cold winter day and let it dry out on the top side overnight. Any way to dry the top side while the bottom remains as it is should do the trick.

To be continued in part 3, where I offer 6 tips for dealing with flat wood.

.

Have something to say? Share your thoughts with us in the comments below.