Quartersawn lumber stays flat, but flatsawn lumber does not (ironic, I know). Flatsawn lumber cups during the drying process and it even cups after it’s dry if not cared for properly. Wide boards are especially fussy and panel glue-ups can be a giant pain in the tuchus.

I deal with cupped lumber all of the time, and I was reminded of this common problem when a friend of mine was trying to figure out why his wide panel glue-ups had cupped. Whenever I am asked about this, my first question is always, “How did you store your panels after they were assembled and surfaced?” The answer is usually that they laid the panels flat on a table. A quick bit of logic says that a flat panel on a flat table should stay flat, but that isn’t how it works, at least not with solid wood.

Solid wood needs to expand and contract evenly, on both sides, to stay flat. If the panels are placed flat on a table, they can breathe on one side but not on the other. The bottom side will remain as dry or wet as it started, but the top side will shrink or swell depending on the ambient humidity in the room. Usually, this problem arises when lumber is moved from a non climate-controlled environment (like a garage or barn) into a dry, climate-controlled shop, so the top of the panels will shrink and the lumber will cup up and away from the table as it dries.

In a perfect world, rough lumber would be stored for months in the exact same, hermetically sealed environment where the processing is going to happen, but since we don’t live in a bubble, that’s not really possible. Even if you store the lumber in your climate-controlled shop and build in your climate-controlled shop, the climate still changes – in small increments from day to day and more dramatically from season to season. And, since you know that these changes will make your wood expand or contract, it is even more imperative to store surfaced lumber and panels properly to make sure your flat work stays flat.

Again, storage is the key, and there are two approaches to keep things flat. The most common way is to store the wood so that it can breathe on all sides. This is done by keeping it stacked flat on sticks or by storing it upright at an angle, perhaps leaning against a wall. The other approach is to not let the wood breathe at all and keep it wrapped or covered in plastic. I commonly use both tactics, leaning panels against the wall for short-term storage, usually during a day of processing and then covering them with a sheet of plastic for longer storage. Note that dramatic changes in flatness can happen in just hours if the conditions are right (or wrong, in this case).

Check in next week to see how we begin to address and deal with the issue of cupped wood.