3 Tips for 3D Pressing
Stiles-Wemhoner-Eagle-145.jpg

1 Cutting or routing of the parts using high-quality diamond tooling is the first step in producing clean parts. Routing speeds no faster than 500 inches per minute are optimum. Using worn or low-quality tools can lead to excessive loose fiber from the MDF.

2 To keep airborne dirt particles from adhering to parts, put the press and spray booth in a separate room with positive pressure. A positive pressure room has greater pressure inside than outside, making it difficult for airborne contaminates to enter. Spray parts and the press after the glue dries to, again, keep debris from settling onto the parts.

3 When unwinding the foil to run in the membrane press, use an anti-static device to avoid static clinging from the dust particles. Lastly, lightly rub each part with a brush or fine sandpaper to remove the burrs left from the glue. This is a quick process and can substantially decrease the number of rejected parts.

Membrane pressing can add unique and impressive design qualities to finished products. Make certain to maintain the quality of these parts by taking these simple precautions.

Source: Stiles Machinery Inc. For more information call (616) 698-7500 or visit StilesMachinery.com.

Have something to say? Share your thoughts with us in the comments below.