Proposed standard to address drop side and mattress support hazards


WASHINGTON, D.C. - The U.S. Consumer Product Safety Commission (CPSC) voted (5 to 0) today to approve proposed new mandatory standards to address the hazards posed by full-size and non-full-size cribs.


Serious safety hazards with cribs have ranged from drop-side hardware or other drop-side entrapment issues to failures of the mattress support and detachment or breakage of the crib slats. All of these defects can create hazardous gaps allowing a baby to become entrapped and suffocate or fall out of the crib.


The Consumer Product Safety Improvement Act of 2008 (CPSIA) directs CPSC to issue mandatory safety standards for durable infant or toddler products. CPSC’s notice of proposed rulemaking ("NPR") for cribs includes:



  1. a standard for full-size cribs that is substantially the same as ASTM F 1169-10, Standard Consumer Safety Specification for Full-Size Baby Cribs, with one modification . The one modification that CPSC is proposing to the ASTM full-size crib standard would require cribs to be tested without the re-tightening of screws between tests in order to ensure that the tests reflect the lifetime use of the crib; and

     


  2. a standard for non-full-size cribs that is substantially the same as ASTM F 406-10, Standard Consumer Safety Specification for Non-Full-Size Baby Cribs/Play Yards, with certain modifications. These modifications include adding certain requirements that apply to full-size cribs, such as the mattress support performance requirement, the side-impact test, and the order in which performance tests are to be done, applicable to non-full-size cribs so that the new standard for non-full-size cribs is more stringent. The proposal also would restore movable side latch tests to the non-full-size crib standard and would clarify that the proposal does not extend to play yards.

Through close collaboration with ASTM International, consumer groups, industry and other juvenile product experts, improved consensus standards were approved June 1, 2010, that incorporated key safety requirements recommended by CPSC staff. The ASTM standards and the proposed CPSC standards contain design requirements that essentially prohibit traditional drop sides (up and down movement of an entire side of the crib).

CPSC staff is working to finalize the proposed mandatory crib standards in 2010.


CPSC Commissioner statements attached to this release: Chairman Inez M. Tenenbaum (pdf), Commissioner Nancy A. Nord (pdf), and Commissioner Anne M. Northup (pdf)

---


The U.S. Consumer Product Safety Commission is charged with protecting the public from unreasonable risks of serious injury or death from thousands of types of consumer products under the agency's jurisdiction. The CPSC is committed to protecting consumers and families from products that pose a fire, electrical, chemical, or mechanical hazard. The CPSC's work to ensure the safety of consumer products - such as toys, cribs, power tools, cigarette lighters, and household chemicals - contributed significantly to the decline in the rate of deaths and injuries associated with consumer products over the past 30 years.


To report a dangerous product or a product-related injury, call CPSC's Hotline at (800) 638-2772 or CPSC's teletypewriter at (301) 595-7054. To join a CPSC e-mail subscription list, please go to https://www.cpsc.gov/cpsclist.aspx. Consumers can obtain recall and general safety information by logging on to CPSC's Web site at www.cpsc.gov.


 

Have something to say? Share your thoughts with us in the comments below.