Q: We are edge gluing several strips together into a panel. Occasionally we have a joint failure and when I look at the broken joint, I see plenty of glue, but it just didn't hold together well. There is no wood failure. Can you tell what is going on?
A: It is difficult to be 100 percent certain without actually seeing a sample or two.
However, what you are describing would be typical of a failure when the two pieces of wood are not close enough together. That is, you have a glue line that is too thick.
Most adhesives used with wood require the wood to be between 0.002 and 0.006 inches apart. At that closeness, I do not think that you would see "plenty of glue."
Thick glue lines can develop for several reasons, with the first two being the most common:
- Surfaces that are not flat or true at the time of gluing
- Pressure is too low (usually in just a small region)
- Glue spread rates are too high
- Adhesive is too thick or viscous
Have something to say? Share your thoughts with us in the comments below.